SATO CL408-412e manual Service Mode Table, Description, Menu

		Unit 4: Printer Configuration
		SERVICE MODE (TABLE 4-4)
MENU		DESCRIPTION
		Is the first menu screen of the Advanced Mode. The Advanced Mode is provided to make basic
		printer operational adjustments. Typically, once these adjustments or settings have been made,
ADVANCED MODE
		they will not require additional address unless a new bob is downloaded.
		Is only a transitional menu screen to access the Service Mode.
		The Card Mode allows the operator to manage or format the expanded memory card. Is only a
CARD MODE
		transitional menu screen to access the Service Mode.
		The Service Mode allows the programming of various dimensional settings, sensor thresholds,
SERVICE MODE
		and language options.
		When setting the sensor threshold, the voltage shown on the top line is the measurement using
		only the media’s backing paper placed over the sensor. The lower line displays the measurement
GAP	[ X.XV ]
		with the media and backing paper combined.
INPUT	[ X.XV ]
		DSW2-2 determines which sensor will be enabled for use.
		Allows it to be determined if the printer will feed a label when it is placed online to ensure proper
AUTO ONLINE FEED
YES	NO	media placement for printing.
FEED ON ERROR		Allows it to be determined if the printer will feed a label when an error condition is cleared.
YES	NO
		Allows it to be determined if the printer will print the last label in memory when the FEED key is
REPRINT W/FEED
YES	NO	pressed in the normal, online mode.
		Allows the selection of whether to accept the default setting or to set the backfed distance other
FORWARD / BACKFEED
DISTANCE	DEFAULT	than the default setting.
		Allows the backfeed distance to be set. If using thermal transfer for printing, set the feed distance
FORWARD / BACKFEED
DISTANCE	XXXMM	less than 30mm to avoid detection of the ribbon end by accident.
		Allows selection of the conditions that regulates Pin-9 of the EXT connector. MODE1 enables
EXT PIN9 SELECET
		Pin-9 when the printer goes online and a print quantity is displayed. MODE2 enables Pin-9 when
MODE1	MODE2	the printer goes online without consideration of print quantity.
		Allows the hexadecimal value to be specified for the character replaced with the Euro Character.
EURO CODE
	D5	The default is D5H. ASCII (213)

CL408-412e Supplemental Manual 4-21 PN: 9001159A