SATO CX208/212 manual Resulting Command Code

CX208/212 Programming Guide

2.This command must be sent as an independent data stream immediately following the <ESC>A Start code and immediately preceding the <ESC>Z Stop code. No other commands can be included in the data stream.

3.If more or less than nine commas are included in the command, the entire command sequence will be ignored. The command must contain exactly nine commas.

4.If two characters are specified for a parameter, it will be interpreted as a hex value. For example:

Command Parameter	Resulting Command Code
2B	+
+	+

If a combination of characters are outside the hexadecimal range, the entire command sequence will be ignored.

5.The current protocol command codes may be verified by printing a self test label (<ESC>CT).

Page 92 PN 9001092 Rev. A SATO CX208/212 Printers