SATO CX208/212 Line Feed, Command Structure, Command Function, Input to Printer, Printer Output

CX208/212 Programming Guide

		Line Feed
Command Structure	<ESC>Eaaa
	aaa =	Number of dots (001-999) between the bottom of the
		characters on one line to the top of the characters on
		the next line
	Example:	<ESC>E010
	Placement: Preceding the text that will use the line feed function
	Default:	None
Command Function	o print multiple lines of the same character size without specifying a
	new print position for each line. With the Line Feed command, specify
	the number of dots you want between each line. Then, send an ASCII
	CR> at the end of each line of text. The printer automatically
	identifies the size of the last character, moves down the number of
	dots specified, and begins printing the next line.
Input to Printer	<ESC>THISIS<ESC>Q1<SC>ZAE010THE<ESC>H0050<ESC>V0050<ESC>L0202<ESC>S1ST2ND3RLINE>CR><>CR>
Printer Output
	1. It is effective only for the current data stream.
Special Notes

2. When printing lines or boxes in the same data stream with the Line Feed command, the Lines and Boxes command should be specified last, preceding <ESC>Q Quantity command.

3. This command is invalid only if the value specified is zero.

4. Following this command with a <CR> character will allow you to print with auto line feed. Tthe print position will be determined from the value specified and the H value set in the printer. If you specify several H values after this command, the print position will be determined by the H value last specified. You must redefine the font to be used after each H command.

Page 47 PN 9001092 Rev. A SATO CX208/212 Printers