Extron electronic IPI 100, IPI 200 manual Setting the IP address using the ARP command

Initial Configuration, cont’d

Setting the IP address using the ARP command

An IPI 200 Series unit’s IP address can be set using the DOS Address Resolution Protocol (ARP) command.

The IPI 200 Series unit must be:

•physically connected to the network

•at its factory default IP address

To set an IP address using the ARP command:

1. Open a command prompt window on a local PC. On Windows XP, a command prompt window can be found at:

Start > All Programs > Accessories > Command Prompt

2. At the command prompt type:

arp - s <IP address> <MAC address>

example: C:\>arp -s 192.168.254.254 00-05-A6-00-30-5F

The example command assigns IP address 192.168.254.254 to the device that has a MAC address of 00-05-A6-00-30-5F.

3. To confirm the new IP address is active, perform a ping command to the new IP address.

example: C:\>ping 192.168.254.254

If the IP address setting was successful, the device replies 3 or more times:

Reply from <IP address>: bytes=32 time <1ms TTL=64

4-6 IPI 100 and IPI 200 Series • Initial Configuration