Extron electronic IPI 100, IPI 200 manual Command/response table for SIS commands, +X20

SIS Programming and Control, cont’d

Command/response table for SIS commands

Command	ASCII (Telnet\⤀	URL Encoded	Response	Additional Description
	(host to intercom\⤀	(host to intercom\⤀	(intercom to host\⤀
Relay functions
Force relay on	1*1O	1 %2A1 O	Rly 1 *1]	Turn relay on.
Force relay off	1*0O	1 %2A0 O	Rly 1 *0]	Turn relay off.
Toggle relay	1*2O	1%2A2O	Rly 1* X%]	Toggle relay on/off.
				X% = 1 (on) or 0 (off).
Pulse relay	1*3*X6# O	1%2A3%2AX6# O	Rly 1 * X%]	Set relay’s pulse time (X6#) in
			Rly 1 * X%]	20 ms increments from 1 (20 ms,
				minimum) to 65535 (1310700 ms,
				maximum).
				Default pulse length is 25 = 500 ms.

NIf the verbose mode is enabled, there are two responses from the unit because the relay is pulsed. During a pulse, the relay is toggled to its opposite state and then back to the original state.

View the relay	1O	1O	Rly 1 * X%]
state
Front panel security lockout modes (executive modes\⤀
Off24	0X	0X	Exe 0]	Executive mode is off.
On24	1X	1X	Exe 1]	Executive mode is on.
View lockout	X	X	X20(]	X20(= Front panel lockout
mode status				(executive mode) status
				0 = off/unlocked (default)
				1 = on, disable/lock the front panel
Example:	X	X	0]	Executive mode is off.
Status commands
View all	11S	11S	shows responses to commands
voltage and			12S•13S•14S•15S•16S•20S ]
temperature
status
View +12 V	12S	12S	+X20^]	X20^= Voltage (in volts)
P/S voltage
View +5 V IR	13S	13S	+X20^]
receiver port
voltage
View +3.3 V	14S	14S	+X20^]
IP Link/FPGA
voltage
View +1.5 V	15S	15S	+X20^]
FPGA voltage
View internal	20S	20S	X20&]	X20&=Temperature in degrees
temp. status				Celsius (the response is 3 digits

including leading zeros)

B-8 IPI 100 and IPI 200 Series • SIS Programming and Control