Extron electronic IPI 100, IPI 200 manual Installling Button Labels, Text

Button Labels

Installling Button Labels

The button assembly consists of a clear lens cap, the label and a white diffuser. To remove a button assembly and replace a label:

1.Use a small flat-blade screwdriver to gently pry the button assembly away from its plunger/base.

			ON
			MIC
			LEVEL
INTERCOM			HIGH
			MED
			LOW
			ADMINE
			OFFIC
		LAB	4	IPI	104
	SECURITY
		3
HELP	2
DESK

2. Locate the small corner notch on the lens cap and slide	Plunger
the screwdriver between the lens cap and the
diffuser, as shown in the figure at right.

Using a rotating motion of the screwdriver (see the figure at right), carefully pry the two pieces apart.

TEXT

Base

3.Replace the label with the new button label.

4.Press the lens cap and diffuser together and reinstall the button assembly into its plunger/base.

5.Repeat steps 1 through 4 for each button you plan to re-label.

Clear Lens

Notch

Separating the two- piece button here at the corner.

Diffuser

Button Label

Pry the two pieces apart.

D-4 IPI 100 and IPI 200 Series • Button Labels