Extron electronic IPI 100 manual X2@ , X6$,X1$ EB , Bmd X6$,X1$ , X6$ EB , Cc , X3# CA , X4!

SIS Programming and Control, cont’d

Command	ASCII (Telnet\⤀	URL Encoded	Response	Additional Description
	(host to intercom\⤀	(host to intercom\⤀	(intercom to host\⤀
Read verbose	E CV }	WCV	X2@ ]
mode status
Set the	E X6$,X1$ EB }	W X6$%2C X1$ EB	Bmd X6$,X1$ ]	X6$= Broadcast repetition interval
broadcast				in seconds (0 to 255 [4.25 minutes],
interval24				default = 0 = off).
				X1$= subnet address (xxx.xxx.xxx.
				xxx). Default broadcast address:
				255.255.255.255.
Set broadcast	E X6$ EB }	W X6$ EB	Bmd X6$,X1$ ]	X1$= Default broadcast subnet
interval				address: 255.255.255.255.
to default
address24
Clear	E 0 EB }	W 0 EB	Bmd X6$,X1$ ]	X6$= Broadcast repetition interval
broadcast				set to 0 (off).
interval24				X1$= Default broadcast subnet
				address: 255.255.255.255.
View	E EB }	W EB	X6$,X1$ ]
broadcast
interval
Set broadcast	E {port#}*X7! , X7@ PB}		Bpt {port#}*X1* ]
port		W{port#}*X7! , X7@ PB
View	E PB}	WPB	{port#}*X1* ]
broadcast port

and MAC

N{port#} = UDP outgoing port, X7! * X7@ = MAC address for UDP unicast transmissions.

NChanges to the PB command become effective in kernel versions 1.53 or higher.

Get	E CC }	WCC		verbose modes 0/1: {# of
connections				connections} ]
listing				verbose modes 0/1: Icc {# of
				connections} ]
Password and security settings
Set	E X3# CA }	W X3# CA	Ipa• X4! ]
administrator
password24
Clear	E • CA }	W%20 CA ]	Ipa• ]	Clear/remove all passwords
administrator				(administrator and user).

password24

NA user password cannot be assigned if an administrator password does not exist. Also, if the administrator password is cleared, the user password is also cleared.

Read	E CA }	WCA	X4! ]
administrator
password

X2@= verbose mode status:

0 = clear/none, default for Telnet connections; responses are not echoed to the host

1 = verbose mode is on, default for RS-232 host control; responses are echoed to the host and displayed to the user 2 = send tagged responses for queries

3 = verbose mode is on and tagged responses are sent for queries.

X3#= Administrator password has 4 to 12 alphanumeric characters and is case sensitive. Special characters (spaces, symbols) not allowed.

X4!= Password displayed on screen. When the IPI connects to a host device via RS-232, the password is shown. When the connection is via IP, 4 asterisks are shown (or an empty field if no password has been assigned).

B-12 IPI 100 and IPI 200 Series • SIS Programming and Control