Extron electronic IPI 200, IPI 100 manual X3# CU IpuX4! , Ck , X5@ or, Pvl X5@

Command	ASCII (Telnet\⤀	URL Encoded	Response	Additional Description
	(host to intercom\⤀	(host to intercom\⤀	(intercom to host\⤀

Set user	E X3# CU }	W X3# CU	Ipu•X4! ]
				X3#= user password
password14, 24				X4!= Password displayed on
				screen.

NA user password cannot be assigned if an administrator password does not exist. Also, if the administrator password is cleared, the user password is also cleared.

Clear user	E • CU }	W%20CU	Ipu• ]	This clears the user password only.
password24
Read user	E CU }	WCU	X4! ]
password
Read	E CK }	WCK	X5@ ] or	For X5@
connection’s			Pvl X5@ ]	11 = user
security level				12 = administrator

Remapping port designations

For security reasons the network administrator may wish to assign new/different port numbers to the controller’s Telnet, Web browser, and direct access ports or to disable one or more ports. Typically Telnet uses port 23, Web access is via port 80 (HTTP), and direct access is via port 2001.

CDo not set two or more ports to the same port number. Setting two ports to the same number could cause networking conflicts and will also result in an E13 (invalid parameter) error.

NIf you remap a port, you must set the port number to 1024 or higher, unless you reset the port to the default number or disable the port by setting it to 0.

Set Telnet	E {port#}MT }	W{port#}MT	Pmt {port#} ]
port24
Reset Telnet	E 23MT }	W23MT	Pmt 00023 ]
port 24
Disable Telnet	E 0MT }	W0MT	Pmt 00000 ]
port24
Read Telnet	E MT }	WMT	{port#} ]
port
Set HTTP	E {port#}MH }	W{port#}MH	Pmh {port#} ]
port24
Reset HTTP	E 80MH }	W80MH	Pmh 00080 ]
port24
Disable HTTP	E 0MH }	W0MH	Pmh 00000 ]
port24
Read the Web	E MH }	WMH	{port#} ]
port map
Set Direct	E {port#}MD }	W{port#}MD	Pmd {port#} ]
Access port24
Reset Direct	E 2001MD }	W2001MD	Pmd 02001 ]
Access port24
Disable Direct	E 0MD }	W0MD	Pmd 00000 ]
Access port24
Read Direct	E MD }	WMD	{port#} ]
Access port

Set a Telnet port number that does not conflict with any other ports.

Reset the Telnet port to port 23.

Disables the port.

Set a HTTP port number that does not conflict with any other ports.

This resets the HTTP port to port 80.

Disables the port.

Set a direct access port number that does not conflict with any other ports.

This resets the direct access port to

port 2001.

Disables the port.

IPI 100 and IPI 200 Series • SIS Programming and Control B-13