SATO GL408/412E manual 16, Printer Management Mode

Unit 4: Printer Configuration

PRINTER MANAGEMENT MODE

This chapter provides the programming sequences required to connect and operate the printer through a sytems network. The menu screens that will appear and will require address, is dependent on the interface type to be used.

Refer to the Menu Definition Tables in the following chapter to provide an explanation of each menu screen.

POWER
	INTERFACES
ONLINE	Printer Mgmt
	Chosen:	Chosen:
LINE	Lan, WLAN, or Serial	Parallel, Centronic, or USB
	ENTER	ENTER
OFFLINE	Printer Mgmt	Printer Mgmt
	SNC Port	SNC Port
	Mgmt Protocol	Mgmt Protocol
	SNC Port Number	Select Port
FUNCTION	SNC Port Timeout	Baud Rate
	Status Port Numb	Word Length
	Mgmt Port Number	Stop Bits
INTERFACES		Parity
	SNC Port	Modem
		Modem NUM
	Disable*	Modem Status
		Dial Method
	Serial
	Ethernet
Interface
Mode
ENTER
	Disable	Ethernet	Serial
INTERFACES	ENTER	ENTER	ENTER
Serial	Mgmt Protocol	Mgmt Protocol	Mgmt Protocol
Parallel
LAN / WLAN	PXML*	PXML*	PXML*
Centronics
	Status Port Numb	SNC Port Number
	XXXXX*	XXXXX*
	Mgmt Port Number	SNC Port Timeout
	XXXXX*	100 seconds*	Select Port
			Debug*
		Status Port Numb	Host
		XXXXX*
		Mgmt Port Number
		XXXXX*
Host	Debug
ENTER	ENTER
Deselect Serial	Baud Rate	Modem	Mgmt Port Number
Host Interface	19200*	Disable*	XXXXX*
	Word Length	Modem NUM
	8*	Enable*
	Stop Bits	Modem Status
	1*	Enable*
	Parity	Dial Method
	None*	Tone*

Figure 4-16, Printer Management Mode

GL408-412e Operator Manual 4-19 PN: 9001163A