SATO GL408/412E manual TGL Emulation Mode, Tgl

Unit 4: Printer Configuration

TGL EMULATION MODE

This chapter provides the programming sequences required to correlate the printer’s interpreter language with that of TEC interpretor language. Use the keys of the printer’s operator panel to select and enter the required options.

Refer to the Menu Definition Tables in the following chapter to provide an explanation of each menu screen.

ATTENTION: Perform the following programming sequence only if this is the emulation type required. Instead, refer to the appropriate emulation chart.

POWER

ONLINE

LINE

OFFLINE

FUNCTION

EMULATION

Emulation

Mode

ENTER

EMULATION

Select

Select

TGL*

TGL Setup

Active

Print Errors

Character Set

Slash Zero

Image Scale

SFCC Select

EURO Symbol

Speed CMDs

AY Intensity CMD

U1/U2 Move CMDs

XS Sensor Param

XS Media ‘C’ Act

XS Media ‘D’ Act

AR Pre-Feed CMD

AX Fine Adj. CMD

Page alignment

Vert. DPI Adjust

Status Response

Active	U1/U2 Move CMDs
Yes*	Process*
Print Errors	XS Sensor Param
Disable*	Process*
Character Set	XS Media ‘C’ Act
PC-850*	Continuous*
Slash Zero	XS Media ‘D’ Act
Disable*	Tear-Off*
Image Scale	AR Pre-Feed CMD
Disable*	Process*
SFCC Select	AX Fine Adj. CMD
Auto Select*	Process*
EURO Symbol	Page alignment
0xB0*	Center*
Speed CMDs	Vert. DPI Adjust
Process*	0*
AY Intensity CMD	Status Response
Process*	Disable*

Figure 4-13, TGL Emulation Mode

GL408-412e Operator Manual 4-16 PN: 9001163A