SATO GL408/412E manual Read only, Factory defaults for SEG1 through SEG4 are 000, 000, 000, Only

		Unit 4: Printer Configuration
	LOCAL AREA NETWORK (LAN) INTERFACE MODE (TABLE 4-8)
MENU		DESCRIPTION
		This menu allows the IP Address to be set for the TCP/IP protocol in four three-digit segments
		(SEG1 through SEG4). If the IP Address is assigned by Bootp, ARP, or DHCP it is dynamic and
		read only.
		The factory defaults for SEG1 through SEG4 are 000, 000, 000, and 000.
IP Address
XXX.XXX.XXX.XXX		Note: When changing the IP Address, the printer resets the Network Interface Card (NIC) when
		the printer is placed online. When the printer resets the NIC, the LCD displays DO NOT POWER
		OFF. After the NIC has completed initialization, the LCD displays E-NET INIT to signal that the
		NIC andd printer are in initialization process. When both the NIC and printer have completed the
		initialization, theLCD displays E-NET READY.
		Allows the Subnet Mask to be set for the TCP/IP protocol in four three-digit segments (SEG1
		through SEG4). If the Subnet Mask is assigned by Bootp, Arp or DHCP, it is dynamic and read
		only.
		The defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
Subnet Mask
XXX.XXX.XXX.XXX		Note: When changing the Subnet Mask, the printer resets the NIC when the printer is placed
		online. When the printer resets the NIC, the LCD displays DO NOT POWER OFF. After the NIC
		has completed its initialization, the LCD displays E-NET INIT to signal that the NIC and printer are
		in the initialization process. When both the NIC and printer have completed initilization, the LCD
		displays E-NET READY.
		Allows the Gateway Address to be set for the TCP/IP protocol in four three-digit segments (SEG1
		through SEG4). If the Gateway Address is assigned by Bootp, ARP, or DHCP, it is dynamic and
		read only.
		The defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
Gateway Address
XXX.XXX.XXX.XXX		Note: When changing the Gateway Address, the printer resets the NIC when the printer is place
		online. When the printer resets the NIC, the LCD displays DO NOT POWER OFF. After the NIC
		has completed its initialization, the LCD displays E-NET INIT to signal that the NIC and printer are
		in the initialization process. When both the NIC and printer have completed initialization, the LCD
		displays E-NET READY.
		This is an informational screen that displays the manufacturer’s assigned number. This number is
		unique for each NIC.
MAC Address
XXX.XXX.XXX.XXX
		Allows the DHCP protocol to be enabled or disabled through this menu.
		The factory default is Disable.
DHCP
Disable*		Note: Consult with your systems administrator for the appropriate setting.

WIRELESS LOCAL AREA NETWORK (WLAN) INTERFACE MODE (TABLE 4-9)

MENU	DESCRIPTION
	Permits entry into the INTERFACES Mode.

INTERFACES

GL408-412e Operator Manual 4-56 PN: 9001163A