General Information
Subnet Mask
With the help of the subnet mask, large networks can be split up into subnetworks. In this case, the user IDs of the IP addresses are assigned to the various subnetworks.
The TPG60 is configured not to use subnetworks by default. If you wish to use a subnetwork, you can configure the relevant parameter via the TPG Homepage or the
1.6Safety Regulations
Before starting the initial operation procedure of the TPG60, please note the safety regulations in the Quick Installation Guide.
1.7First Steps
This section provides all the information that you need to operate the TPG60.
Proceed as follows:
1.Connect the TPG60 to the network and the mains supply; see Quick Installation Guide.
2.Make sure that an IP address is stored in the TPG60; see: ’Saving the IP Address in the TPG60’ Ö11.
3.Define the ThinPrint® port, the bandwidth, and the printers to
which the TPG60 will send print jobs; see: ’ThinPrint® Settings’ Ö48.
ªThe TPG60 is operational.
TPG60 User Manual | 10 |
