SEH Computertechnik TPG60 user manual InterCon-NetTool IP Wizard

General Information

Requirements

For this purpose, the TPG60 picks an IP address at random from the address range 169.254.0.1 to 169.254.255.254 which is reserved for ZeroConf and sends a query to the network. If this IP address has already been assigned elsewhere in the network, the TPG60 will receive a message. The TPG60 then sends another query with a different IP address. If the IP address is available, it is saved in the TPG60.

If you wish to use an IP address different from the one assigned via ZeroConf, you can save a freely definable IP address in the TPG60 later on.

InterCon-NetTool (IP Wizard)

You can easily enter the desired IP address and save it in the TPG60 using the IIP Wizard of the InterCon-NetTool, see: ’Administration via the InterCon-NetTool’ Ö17.

The IP Wizard helps you to configure the TCP/IP parameters, e.g. the IP address. You can choose between the manual configuration and the automatic configuration via boot protocols.

Saving the IP address via the InterCon-NetTool in networks with routers is only possible if the router forwards multicast requests and if network devices are searched for via multicast.

;The TPG60 is connected to the network and the mains voltage.

;The InterCon-NetTool is installed on your local system.

Proceed as follows:

1.Start the InterCon-NetTool.

2.Mark the TPG60 in the print server list.

The TPG60 is displayed in the print server list under 'ZeroConf' with an IP address from the address range 169.254.0.1 through 169.254.255.254, which is reserved for ZeroConf.

3.Select Installation – IP Wizard from the menu bar.

4.Follow the instructions of the Wizard.

ªThe settings are saved.

TPG60 User Manual 12