IMPORTANT INSTRUCTIONS
Drain Water Function
Perform the Drain Water function at least once a day after cooking with steam. It takes up to 7 minutes.
The Drain Water Function helps prevent scale build up and removes left over water.
| P R O C E D U R E |
|
1 | Remove the water tank. Ensure |
|
| that no food is in the oven. Press |
|
| INFO/KITCHEN TIMER once |
|
| to select In F1. | x 1 |
2 | Press START/AUTO MIN- |
|
| UTE. In F1 will flash on and off |
|
| in the display during the Drain | x 1 |
| Water function. |
3 When the drain function has ended and the oven is cool, wipe the oven cavity. Wait a few minutes, then empty the drip tray.
NOTES:
1.The water tank must be removed before starting this procedure.
2.If Drain Water Function is set, Energy Save Mode will be cancelled temporary.
Descale Function
White or gray grains, also called scale, may form in the water circuit inside the oven during steam generation, which could cause the oven to malfunction.
When "DESCALE (fl ashing)" is shown in the display, be sure to carry out Descale function immediately. It takes about 1 hour (for descaling using citric acid is for about 30 min. The rinse time is approx. 30 min.).
P R O C E D U R E
1 Pure citric acid, available at some chemists, or bottled 100% lemon juice with no pulp are used for descaling. Choose one and prepare the descaling solution.
To use pure citric acid, dissolve 1 tablespoon of pure citric acid crystals in 500ml of water in a
To use 100% bottled lemon juice, check that there is absolutely no pulp in it. If there is pulp or you are not sure, strain through a fine strainer. Measure 70ml of the strained lemon juice and add it to 500ml of water. Stir well and pour into the water tank to the MAX mark.
Place the water tank in the oven correctly and push firmly into place.
2 Press INFO/KITCHEN
TIMER twice to select In F2.
x 2
3 Place the glass tray in lower position (position 2). Ensure it is touching the back wall of the oven.
4 | Do not place any food in the |
|
| oven. Close the door firmly. Press |
|
| START/AUTO MINUTE to begin | x 1 |
| descaling (for about 30 min.). | |
5 | When the oven has stopped and is cool, remove | |
| water tank, empty, rinse and refill with room |
|
| temperature drinking water to the MAX mark. |
|
| Replace the water tank. Empty the drip tray and | |
| replace it. |
|
| Remove the glass tray, empty, rinse |
|
| and dry. Follow step 3 to replace |
|
| the glass tray. Close the door firmly. |
|
| Press START/AUTO MINUTE. | x 1 |
| Rinsing will start (for about 30 min.). | |
|
| |
6 When rinsing has ended and the oven is cool, remove water tank and empty. Remove the glass tray and empty. Wipe oven cavity to dry. Wait a few minutes and then empty the drip tray.
NOTE:
If Descale Function is set, Energy Save Mode will be cancelled temporary.
9
