Chapter 9: Message transfers

9-6 Remote programming and remote monitor functions

The remote programming and remote monitor functions are methods for operating a PC on another node connected to the FL-net. These are proprietary SHARP functions. These functions can be used only between PCs that are quipped with SHARP FL-net modules (boards). You can access these functions using the following support devices.

-Hand held programmer: JW-14PG

-Ladder software: JW-100SP, JW-92SP, and JW-52SP

Although these functions use request TCD (1001) and response TCD (1201) in transmission type mes- sages, users are not required to make any settings.

[1]Function

- When connecting to a standard network.

Support

tool

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

n-2

 

 

 

n-1

 

 

 

 

 

n

 

 

 

 

 

n+2

 

n+2

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

FL-net

 

You can do the following using a support device connected to node "n."

 

- Change the program (Writing to the program while the PC is operating is not allowed, for safety

 

reasons. Change the program only after stopping the PC operation.)

 

9

- Monitor remotely

 

 

 

 

- Change the parameter memory (only possible using the JW-14PG).

 

- When connected to an expansion network

 

 

 

 

 

 

Support

 

 

 

tool

 

 

*

 

n-2

n-1

ｎ

n+1 n+2 m m+1 m+2

FL-net

FL-net

*The JW20H (JW-20FL5/20FLT) cannot be used as a junction station ("n+2" station or "m "station). Use a JW30H (JW-20FL5/20FLT) or a JW50H/70H/100H (JW-50FL).

Using a support tool that is connected to node "n," you can do the following.

-Change the program (Writing to the program while the PC is operating is not allowed, for safety reasons. Change the program only after stopping the PC operation.)

-Monitor remotely

-Change the parameter memory (only possible using the JW-14PG).

9-45