M6 bolts 141
Chapter 15: Appendix
Tap connector
LAN transceiver
Installation of a tap in the main case of a transceiver
Transceiver (tap type)
To connect a tap type transceiver to a coaxial cable, make a hole in the coaxial cable insulation and insert a probe that will make contact with center conductor in the coaxial cable. Remove the insulation around the coaxial cable using a special tool.
Supply power from a node to the transceiver (12 VDC) using a transceiver cable. Some nodes may require a separate 12 VDC power supply in order to use the transceiver cable. For details, see the hardware manual for your node.
The "SQE" switch setting on a transceiver is made as follows.
1.ON when connected to a node.
2.OFF when connected to a repeater.
Coaxial cable
Transceiver cable (AUI cable)
Transceiver
12VDC external power supply
AUI connector
When using an AUI external power input terminal block
12 VDC (depends on the15 model used)
Transceiver (tap type) for Ethernet cable