Sharp JW-20FL5, JW-20FLT, JW-50FL, Z-336J manual 70

Chapter 8: Cyclic Transfer

(3) For the JW50H/70H/100H

			Address of the data memory that can be allocated to
			common memory
			Bit address(8)	Byte address(8)	File address(8)
		Relay	00000 to 15777	ｺ 0000 to ｺ 1577	000000 to 001577
		TMR/CNT contact point	T-C0000 to 0777	ｺ 1600 to ｺ 1777	001600 to 001777
			T-C1000 to 1777	ｺ 1300 to ｺ 1477*	001300 to 001477 *
		TMR/CNT/MD current value	---	b0000 to b1777	002000 to 003777
				09000 to 09777	004000 to 004777
				19000 to 19777	005000 to 005777
				29000 to 29777	006000 to 006777
	File 0			39000 to 39777	007000 to 007777
			49000 to 49777	010000 to 010777
		Register	---	59000 to 59777	011000 to 011777
				69000 to 69777	012000 to 012777
				79000 to 79777	013000 to 013777
				89000 to 89777	014000 to 014777
				99000 to 99777	015000 to 015777
				E0000 to E0777	016000 to 016777
8				E1000 to E1777	017000 to 017777
		File 1	---	---	000000 to 177777
		File 2	---	---	000000 to 177777
		File 3	---	---	000000 to 177777
		to	to	to	to
		File 7	---	---	000000 to 177777

*ｺ1300 to ｺ1477 (file addresses 001300 to 001477) are for shared use with the general-purpose relays. Therefore, if a timer/counter is set up with 1024 points, these file addresses cannot be used for the general-purpose relays.

-The relationship between the PC model (on which the memory module is installed) and the file memory is as follows.

PC model	Integrated memory	File memory
	module
JW50H	---	File 0, 1 (000000 to 037777)
	JW-1MAH	File 0, 1 (000000 to 037777)
JW70H	JW-2MAH	File 0, 1 (000000 to 177777)
JW100H	JW-3MAH	File 0, 1, 2
	JW-4MAH	File 1 to 7

- The top address parameter is a word based address. See page 8-11.

8-6