Sharp JW-20FL5, JW-20FLT, JW-50FL, Z-336J 12-3How to set parameters

Chapter 12: Parameters

12-3 How to set parameters

[1] When the JW-20FL5/20FLT or Z-366J is used

Set parameters of JW-20FL5/20FLT and Z-336J as optional parameters of the control module (CPU board). Determine the area of the optional parameters using the module No. switch set value of JW- 20FL5/20FLT and Z-336J. The parameters occupy 64 bytes per module.

Module No. switch	Parameter address(H)
setting value
0	00 to 77
1	00 to 77
2	00 to 77
3	00 to 77
4	00 to 77
5	00 to 77
6	00 to 77

Note: Do not set switch SW3 outside the range of 0 to 6.

- Relationship between the host PC and the control module

FL-net module		Host PC	Control module
		JW20H	JW-21CU/22CU
JW-20FL5			JW-31CUH1
JW-20FLT		JW30H	JW-32CUH1
			JW-33CUH1/2/3
FL-net	Host J-board		CPU board
board
Z-336J	Z-300 series		Z-311J/312J/313J
	Z-500 series		Z-511J

How to set the parameters using the JW-14PG

This paragraph describes parameter setting procedures (in system memory) using the hand-held programmer JW-14PG.

1Connect the JW-14PG to the PG port on the control module

(CPU board.)
2 Set the PC to program mode.	JW-14PG

3Set to the initial mode (parameter setting).

4Select the option parameter and enter "2" for the module No. switch number.

5Rewrite start switch to 00(H). Reading parameter address 77(8).

← Reading a prameter address(H)

(The modules shown below are installation examples)

JW-20FL5

Control module (JW-33CUH)

Connection cable (JW-22KC/24KC)

JW-14PG screen
				12
I	Parameter
	0)	I/O
	1)	Option
I	Parameter 0 - SW: 2
75		HEX	00
76		HEX	00

IParameter 0 - SW: 2

>77 HEX 00

6Enter IP address (192.168.250.3) for the parameter address 00 to 03(8). Decimal notation of parameter 00.

Decimal display of the setting of parameter 00

01	DCM	168
02	DCM	250
I Parameter
>03	DCM	003

Same as the above, enter the other parameter addresses.

12-3