<P=002>
(Continued)
MD recording and playback
SYMPTOM | POSSIBLE CAUSE | REMEDY |
●A recording cannot be made.
●Is the MiniDisc protected against accidental erasure?
●Did you try to make recording on a play-
●Can you see the "TOC FULL" message in the display?
●Slide the accidental erase prevention tab back to its original position.
●Replace it with a recordable disc.
●Put in another recordable disc with recor- ding space on it.
●Even though a disc has been loaded, "NO DISC" or "ERR" is displayed.
●Playback sounds are skipped.
●The disc is very dirty.
●Is the unit located near excessive vibra- tions?
●Has condensation formed inside the unit?
●Clean the disc.
●Place the unit on a firm, level surface free from vibration.
●Remove the disc and leave the power turned on. The unit should function properly in about 1 hour.
Tape recording and playback
SYMPTOM | POSSIBLE CAUSE | REMEDY |
●A recording cannot be made.
●Is the tape protected against accidental erasure?
●Cover the accidental erase prevention hole.
● Sound | is skipped. | ● The tape is damaged. | ● Replace the tape. |
● Sound | in | ● The capstan and pinch roller are very dirty. | ● Clean the capsten and pinch roller. |
reproduced. |
|
| |
●Sound quivers.
● The cassette cannot be ejected.● Did a power failure occur?● Wait until the power is supplied.
Radio reception
SYMPTOM | POSSIBLE CAUSE | REMEDY |
|
● Radios make unusual noise consecutively. | ● The unit is placed near the TV or computer. | ● When the unit receives a radio broadcast |
|
| ● The aerial direction is not placed properly. | near a TV set, a computer or a wordpro- |
|
| cessor, it may pick up noise. If this hap- |
| |
|
|
| |
|
| pens, try to move the unit from the place |
|
|
| where the noise is picked up. |
|
|
| ● Correct the aerial direction. |
|
|
|
|
|
● The preset channel cannot be recalled. | ● Did you erase the programmed station? | ● Preset the channel again. |
|
|
| ● Redo programming. |
|
|
|
|
|
Remote control |
|
|
|
|
|
|
|
SYMPTOM | POSSIBLE CAUSE | REMEDY |
|
●The remote control does not function or does not operate properly.
●The batteries (polarity) are not inserted properly.
●The batteries inside the remote control are dead.
●The remote control is operated from an in- correct distance or angle.
●Insert properly.
●Replace the batteries.
●Operate it within a range of 0.2 m (8") to 6 m (20') and within an angle of 15 ° to either side of centre.
●The power cannot be turned on from the remote control.
●Is the AC power lead plugged in?
●Connect the AC power lead.
51
