PREPARATION FOR USE
AM loop antenna
1 | 2 |
| 3 |
|
(1) |
| (2) |
|
|
|
|
| ANTENNA |
|
|
|
| AM |
|
|
|
| LOOP |
|
FM aerial |
|
| FM |
|
|
|
|
| |
Right speaker |
|
| Left speaker | |
|
|
| RATED SPEAKER |
|
|
|
| IMPEDANCE ; | Red |
|
|
| 6 OHMS MIN. | |
|
|
|
| |
|
|
| LEFT |
|
|
| Black |
| Black |
|
|
|
| |
|
|
| RIGHT |
|
|
| Red | SPEAKERS |
|
1 | 2 |
| 3 |
|
IUnplug the AC power cord from the AC outlet before connecting or disconnecting any component.
HAntenna connection
Connect the antenna wire to the ANTENNA jack.
(1) FM antenna
Position the FM antenna wire in the direction where the stongest signal can be received.
(2) AM loop antenna
Position the AM loop antenna for optimum reception.
Place the AM loop antenna on a shelf, etc., or attach it to a stand or wall with screws (not supplied).
Notes:
IDo not place the antenna on the unit. It may result in noise generation, since the unit is equipped with digital electronics. Place the antenna away from the unit for better reception.
IIf the AM loop antenna and the FM antenna wire are placed near the AC power cord, interference may result.
HSpeaker connection
Connect each speaker wire to the SPEAKER terminals as shown.
Use speakers with an impedance of 6 ohms or more, as lower impedance speakers can damage the unit.
Cautions:
IConnect the black wire to the minus
IDo not mix the right channel and left channel wiring when connecting the speakers to the unit.
IDo not let bare speaker wires touch each other as this may damage the amplifier and/or speakers.
Note:
IThe speaker grille is not removable.
Left speaker | Right speaker |
For the | For the |
left side | right side |
HPlacing the system
IBe sure to keep space between the units for ventilation.
IKeep the back and sides of this unit at least 2" (5 cm) away from the wall.
IIf any kind of magnet or an electromagnet is placed too close to the TV set and the system, irregular color may be seen.
TV set location
IDepending on the particular location of a TV set, color variations may be seen on the TV screen. If this happens, move the system and its speakers away from the TV and turn off the TV set. After 15 - 30 minutes, turn on the TV again.
The TV's own demagnetising function should eliminate the variations. However, if the color still does not look right, move the system further away from the TV set.
Note:
IA cooling fan is built into this product to avoid heat buildup. When the power is turned on, the cooling fan will run.
5
5 | 98.6.23, 10:09 AM |
