RF4QR/NA
SYNCHRONIZATION CONTROL
When two or more VCRs are connected together, the VCRs can be operated simultaneously just by operating the VCR that has been set to “MASTER”, without using a system controller (sold separately).
There are two modes available: operator mode and administrator/installer mode. The operations that can be carried out in each mode are different.
NOTES:
œ The operation and setting can only be carried out with |
the button of this unit. |
œ Use cables with a thickness of A.W.G.24 (0.2 mm2) or |
more and a length no more than 1.5 m to connect |
VCRs. |
œ It is recommended that you do not connect any more |
than 10 VCRs together. |
œ Only one VCR can be specified at the master unit. |
œ Do not mix operator mode and administrator/installer |
mode in the same installation. |
œ Do not connect the VCRs in a loop. |
œ “TERMINAL SET” in the (OTHERS) menu should |
always be set to “SET1”. |
œ The VCR operation may not e completely |
synchronized depending on the VCR statuses, the |
operating environment and the operation timing. It is |
Operator Mode
This mode lets you carry out basic operations (ejecting, recording, stopping, rewinding and changing the recording speed mode).
NOTE:
œThis mode will not work correctly unless the VCRs are in the same initial state.
1Press the MENU button to display the MAIN MENU.
2Turn the JOG dial to select the “4.WARNING OUT/CONTR. SET” line, then turn the SHUTTLE ring clockwise.
øThe (WARNING OUT/CONTROL SET) menu appears.
<WARNING@OUT@SET>SET@UP
ALARM@@@@@@@@@@@@Y
NON@REC@@@@@@@@@@N
MECHA.PROBLEM@@@@Y
<CONTROL@SET>
EJECT@MODE@@@@@@@EJECT1
OPERATION@@@@@@@@SLAVE
3Turn the JOG dial until the “OPERATION” setting is highlighted, then turn the SHUTTLE ring clockwise.
4Turn the JOG dial to select the desired operation, then turn the SHUTTLE ring clockwise.
recommended that you check the operating statuses |
and menus after carrying out each operation. |
Connection
VCR No. 1 | VCR No. 2 |
CONTROL IN COM CONTROL OUT | CONTROL IN COM CONTROL OUT |
SLAVE . . . . . . . . . . . . .
MASTER . . . . . . . . . .
The function is restricted to only the VCR being operated.
The function is applied to the VCR being operated and all VCRs that are connected after it.
To CONTROL IN terminal
To COM terminal
œWhen the “OPERATION” is set to “MASTER”, “SC” lights on the digital display.
5Press the MENU EXIT button.
English | 41 |
