Connections
Power Supply
Connecting the Power Cord
Plug the supplied power cord into the AC socket on the side of the projector.
Power cord QACCU5013CEZZ
Setup & Connections
Projecting Computer Images
Connecting the Projector to a Computer
You can connect your projector to a computer for projection of full color computer images.
Connecting to a computer using the standard 15-pin Input
RGB cable
1 Connect one end of the supplied RGB cable to the INPUT 1 port on the projector.
2 Connect the other end to the monitor output port on the computer. Secure the connectors by tightening the thumb screws.
3 To use the
4Connect the other end to the audio output terminal on the computer.
|
|
| CAUTION |
|
| • | Before connecting, be sure to turn both the projector and the computer off. After making |
|
|
| all connections, turn the projector on first. The computer should always be turned on |
|
|
| last. |
|
| • | Please read the computer’s operation manual carefully before making connections. |
|
| • | Refer to page 84 “Computer Compatibility Chart” for a list of computer signals compatible |
|
|
| with the projector. Use with computer signals other than those listed may cause some of |
1 | 3 | • | the functions not to work. |
|
| A 3.5 mm stereo minijack to stereo RCA audio cable adaptor may be necessary. | |
| 4 |
| When connecting this projector to a computer, select “RGB” for “Signal Type” |
|
|
| on the GUI menu. (See page 45.) |
|
| • | A Macintosh adaptor may be required for use with some Macintosh computers. Contact |
| 2 |
| your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center. |
| • | AUDIO INPUT 1 can be used to input audio corresponding to the INPUT 1. |