Sharp XG-V10XU Special Mode Adjustment, Checking the Input Signal, Projector, Remote Control

Adjusting the Computer Images (RGB menu only)

Projector Remote Control

1, 6 2, 3, 4

5

Special Mode Adjustment

Ordinarily, the type of input signal is detected and the correct resolution mode is automatically selected. However, for some signals, the optimal resolution mode in “Special Modes” on the “Fine Sync” menu screen may need to be selected to match the computer display mode.

(Slide the MOUSE/ADJUSTMENT switch

MOUSE ADJ.

on the remote control to the ADJ. position.)

1.2.3 4.5.6

(GUI) On-screen Display

1Press MENU.

2Press ß/© to select “Fine Sync”.

3Press ∂/ƒ to select “Special Modes”, and then press ©.

4Press ∂/ƒ to select the optimal resolution mode.

5Press ENTER to save the setting.

6To exit from the GUI, press MENU.

•Avoid displaying computer patterns which repeat every other line (horizontal stripes). (Flickering may occur, making the image hard to see.)

•When inputting DTV 480P or 1080i signals, select the corresponding type of signal in step 4 above.

Basic Operation

Projector Remote Control

1, 4

2, 3

1.2.3 4.5.6

(GUI) On-screen Display

Checking the Input Signal

This function allows you to check the current input signal information.

(Slide the MOUSE/ADJUSTMENT switch	MOUSE ADJ.
on the remote control to the ADJ. position.)

1Press MENU.

2Press ß/© to select “Fine Sync”.

3Press ∂/ƒ to select “Signal Info” to display the current input signal.

4To exit from the GUI, press MENU.

E-48