IMPORTANT SAFEGUARDS
CAUTION |
| "COMPLIES WITH 21 CFR SUBCHAPTER J" | |||
| SHARP PLAZA, MAHWAH, NEW JERSEY 07430 | ||||
|
| SHARP ELECTRONICS CORPORATION | |||
LASER RADIATION- |
| TEL : |
| U.S.A. ONLY |
|
|
|
|
| ||
DO NOT STARE INTO BEAM |
| REMOTE CONTROL |
|
|
|
WAVE LENGTH : 650nm |
| MODEL NO. : RRMCG1564CESA |
|
|
|
| DC3V (1.5VX2PCS.) |
|
|
| |
MAX. OUTPUT : 1mW |
| MADE IN CHINA |
|
|
|
CLASS II LASER PRODUCT |
| FABRIQUÉ AU CHINE |
|
|
|
|
|
|
|
|
|
AVOID
RADIATION IS EMITTED
FROM THIS APERTURE.
Cautions Concerning the Laser Pointer
The laser pointer on the remote control emits a laser beam from the laser pointer window. This is a Class II laser which may impair your sight if directed into the eyes. The three marks shown on the left are caution labels for the laser beam.
•Do not look into the laser pointer window or shine the laser beam on yourself or others. (The laser beam used in this product is harmless when directed onto the skin. However, be careful not to project the beam directly into the eyes.)
•Always use the laser pointer at temperatures between 41°F and 104°F (5°C and 40°C).
•Use of controls or adjustments, or performance of procedures other than those specified herein may result in hazardous radiation exposure.
Laser pointer window
LAMP REPLACEMENT CAUTION
BEFORE REMOVING THE SCREW, DISCONNECT POWER CORD. HOT SURFACE INSIDE ALLOW 1 HOUR TO COOL BEFORE REPLACING THE LAMP. SEE OPERATION MAN UAL.
CAUTION LAMP MAY RUPTURE. |
POTENTIAL HAZARD OF GLASS |
PARTICLES. SEE OPERATION MANUAL. |
ATTENTION RUPTURE POSSIBLE DE LA LAMPE. DANGER POTENTIEL DE PARTICULES DE VERRE. SE REPORTER AU MODE D’EMPLOI.
104˚F
(40˚C)
41˚F
(5˚C)
Caution Concerning the Lamp Replacement
See “Replacing the Lamp” on pages 71 and 72.
Caution Concerning the Lamp Unit
Potential hazard of glass particles if lamp ruptures. In case of lamp rupture, contact your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center for a replacement.
See “Replacing the Lamp” on pages 71 and 72.
Cautions Concerning the Setup of the Projector
For minimal servicing and to maintain high image quality, SHARP recommends that this projector be installed in an area free from humidity, dust and cigarette smoke. When the projector is subjected to these environments, the lens must be cleaned more often. As long as the projector is properly maintained in this manner, use in these environments will not reduce the overall operation life. Please note that all internal cleaning must be performed by an Authorized Sharp Industrial LCD Products Dealer or Service Center.
Notes on Operation
•The exhaust vent, the lamp cage cover and adjacent areas may be extremely
hot during projector operation. To prevent injury, do not touch these areas until they have sufficiently cooled.
• Allow at least 4 inches (10 cm) of space between the exhaust vent and the nearest wall or obstruction.
• If the cooling fan becomes obstructed, a protection device will automatically turn off the projector lamp. This does not indicate a malfunction. Remove the projector power cord from the wall outlet and wait at least 10 minutes. Then turn on the power by plugging the power cord back in. This will return the projector to the normal operating condition.
