![Removing and installing the lamp unit](/images/new-backgrounds/123918/123918145x1.webp)
Replacing the Lamp
Removing and installing the lamp unit
CAUTION
•Be sure to remove the lamp cage by the handle. Be sure not to touch the glass surface of the lamp cage or the inside of the projector.
•To avoid injury to yourself and damage to the lamp, be sure to carefully follow the steps below.
•Replace the lamp more safely by unplugging the power cord after turning off the main power.
|
|
| Lamp 1 Lamp 2 |
|
|
| High angle view |
1 | Turn off the power. | Turn off the main | Remove the lamp cage |
| 2 power. | 3 cover. | |
Press POWER OFF. Wait until | Turn off the MAIN POWER | Loosen the user service screw | |
the cooling fan stops. | switch. (Unplug the power cord.) | that secures the lamp cage | |
|
|
| cover on the back of the |
|
|
| projector. Then slide the cover in |
|
|
| the direction of the arrow (to the |
| or |
| open mark). |
|
|
|
Remove the lamp | Attach the lamp cage cover | 6 | Press POWER ON on projector. LAMP |
4 cage. | 5 and turn on the main power. | REPLACEMENT indicator flashes red. | |
|
|
| Then press ENTER to reset lamp timer. |
Remove the securing screws | Slide the lamp cage cover in the | Press POWER ON, and then | |
from the lamp cage. Hold the | direction of the arrow (to the | press ENTER on the projector. | |
lamp cage by the handle and | close mark) on the back of the |
|
|
pull it horizontally towards you. | projector. Then turn on the MAIN |
| ON |
| POWER switch. |
| |
|
|
| |
Securing screws |
|
|
|
Securing screw |
|
| ENTER |
|
|
| |
Turn off the main power again and | Insert the new lamp |
| Attach the lamp cage |
7 remove the lamp cage cover. | 8 cage. | 9 cover. | |
Turn off the main power switch | Press the lamp cage firmly into | Slide the lamp cage cover in the | |
and slide the lamp cage cover | the lamp cage compartment. | direction of the arrow (to the | |
in the direction of the arrow (to | Fasten the securing screws. | close mark) on the back of the | |
the open mark) on the back of |
| projector. Then tighten the user | |
the projector. |
| service screw. |
Troubleshooting | Maintenance& |
|
|
•You need to reset lamp timer every time when replacing the lamp and confirm it to be reset on “Lamp Timer” menu.