Connecting the Projector to Other Devices

Connecting the Projector to a Computer

Connecting to a Computer Using the DVI to 15-pin D-sub Adaptor and the RGB Cable (INPUT 5)

1 Connect a DVI to 15-pin D-sub adaptor to the projector.

Optional

accessory

DVI to 15-pin D-sub adaptor

Type: AN-A1DV (7.9" (20 cm))

2 Connect the above adaptor to

an RGB cable.

To INPUT 5 terminal

3 Connect the above cable to the computer.

•Secure the connectors by tightening the thumbscrews.

Note

• See “Computer Compatibility Chart” on

page 88 for a list of computer signals

compatible with the projector. Use with

computer signals other than those listed

DVI to 15-pin D-sub adaptor

(sold separately)

RGB Cable

may cause some of the functions not to

work.

 

• When connecting the projector to a com-

puter in this way, select “A. RGB” for “Sig-

nal Type” in the “Options” menu, or select

the “A. RGB” by pressing

on the re-

mote control. See page 69.

 

• A Macintosh adaptor may be required for

use with some Macintosh computers.

Contact your nearest

Authorized

SharpVision Service Center or Dealer.

• Depending on the computer you are us-

ing, an image may not be projected un-

less the signal output setting of the com-

puter is switched to the external output.

Refer to the computer operation manual

for switching the computer signal output

settings.

 

(commercially available)

To RGB output terminal

Notebook computer

-22