Controlling the Projector by a Computer
Controlling the
Projector Using an
RS-232C Cable
When the RS-232C terminal on the projector is connected to a computer with an RS-232C cable (null modem, cross type, commercially available), the computer can be used to control the projector and check the status of the projector. See page 84 for details.
1 Connect an RS-232C cable to the projector.
2 Connect the above cable to the computer.
•Secure the connectors by tightening the thumbscrews.
Note
•Do not connect or disconnect an RS-232C cable to or from the computer while it is on. This may damage your computer.
•The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the operation manual of the computer for details.
To RS-232C terminal
RS-232C cable (commercially available)
To RS-232C terminal
-25
