3 Press , , , or on the remote control or on the projector to select the INPUT mode.
•After pressing once on the projector, use to select the desired input mode.
Note
•When no signal is received, “NO SIGNAL” will be displayed. When a signal that the projector is not pre- set to receive is received, “NOT REG.” will be displayed.
•The INPUT mode is not displayed when “OSD display” is set to “Level A” or “Level B”. (See page 68.)
About the INPUT modes
INPUT 1 | Used for projecting images |
INPUT 2 | from equipment that sends |
(Compo- | component signals or RGB |
nent/RGB*) | signals connected to the |
| INPUT 1 or 2 terminals. |
INPUT 3 | Used for projecting im- |
ages from equipment con- | |
| nected to the |
| put terminal. |
INPUT 4 | Used for projecting im- |
(Video) | ages from equipment |
| connected to the VIDEO |
| input terminal. |
INPUT 5 | Used for projecting im- |
(Digital PC | ages from equipment |
RGB/ | connected to the DVI in- |
Digital PC | put terminal. |
Component/ |
|
Digital Video |
|
RGB/Digital |
|
Video |
|
Component/ |
|
Analog RGB/ |
|
Analog |
|
Component) |
|
*Input the RGB signal of the DTV, not the computer.
INPUT 1 mode
Using RGB*
Using
Component
INPUT 2 mode
Using RGB*
Using
Component
INPUT 3 mode
Using
INPUT 4 mode
Using Video
INPUT 5 mode
Using Analog
RGB
The display varies according to the “Signal Type” with the INPUT 5. The diagram shown above is the example of having selected “Analog RGB”.
Operation Basic