Image Projection

Basic Procedure

Connect the required external equipment to the projector before operating the following procedures.

Info

Power indicator

Lamp indicator

•The language preset at the factory is English. If you want to change the on-screen display to another language, reset the language ac- cording to the procedure on page 36.

1 Plug the power cord into the wall outlet.

•The power indicator illuminates red, and the projector enters standby mode.

2 Press on the remote control or on the projector.

•The power indicator illuminates blue. After the lamp indicator illuminates, the projector is ready to start operation.

Note

•The lamp indicator illuminates, indi- cating the status of the lamp.

Blue: The lamp is ready.

Blue blinking: The lamp is

warming up.

Red: The lamp should be replaced.

•If the projector is put into the standby mode and immediately turned on again, the lamp indicator may take some time to illuminate.

•When controlling the projector using RS-232C commands from a com- puter, wait for at least 30 seconds after the power has been turned on, and then transmit the commands.

", ',\, buttons

ENTER button

STANDBY button

ENTER button

MENU button

INPUT button

STANDBY button

ON button

ON button

MENU button

", ', \, buttons

INPUT buttons

-34