![](/images/new-backgrounds/1264335/264335131x1.webp)
Automation and Drives - SCE
Under Events, select the function StopRuntime by Clicking on the function.
A configured function is referred to in bold print.
Under mode, other settings can be made.
For our panel TP177B, only Runtime is to be terminated.
Save your project and start the consistency check.
Note
If during the consistency check, lines that are marked blue that contain internal warnings occur, you have to regenerate the entire project first.
In the menu “Project“, click on Generator and select Regenerate everything.
Perform a restart at the panel (take it briefly off load).
Switch the panel to the transfer mode.
Transfer your project to the panel.
Click on the END button
Reset the date and the time, and start Runtime.
Preface Installation Project Description Step7 Project HMI Station WinCC flexible Projekt Messages Recipes User Management
T I A Training Document | Page 66 of 129 | Module |
|
| F6 |
Issued: 02/2008 |
| Operator Control with WinCC flexible 2005 |