Sierra Wireless DART 300 manual AT + Commands in Cdpd Mode Command Description

References DART 300 Modem

Table 12-3: AT [+] Commands in CDPD Mode (continued)

Command Description

+WPNEI=<ip> Active NEI Write

	This writes the specified IP address to the table entry indexed by +WS197 (Active NEI Index).
	Changing the NEI entry resets the entry’s CDPD authentication credentials associated with the
	entry. The CDPD service provider must also reset the network’s expected authentication
	credentials for the new address or registration will be unsuccessful.
	If the new value to be written is identical to original value then the authentication credentials are
	NOT reset.
	Before changing the NEI entry, the modem prompts:
	Change c.c.c.c to n.n.n.n?
	where c.c.c.c is the current value for the NEI specified by +WS197 and n.n.n.n is the new value.
	The expected response is “Y” (upper or lower case); otherwise the NEI is not changed.
+WPNEI?	Active NEI Read
	Returns the active NEI, in dotted IP format, from the NEI table as determined by the index in
	+WS197 (Active NEI Index). See also +WPCURNEI.
+WPNEILIST	NEI List
	Displays the four-entry NEI table, with the type and status of each.
	Response:
	1 ddd.ddd.ddd.ddd type status
	2 ddd.ddd.ddd.ddd type status
	3 ddd.ddd.ddd.ddd type status
	4 ddd.ddd.ddd.ddd type status
	where:
	ddd.ddd.ddd.ddd is the NEI in dotted-IP address form
	type is:
	‘P’ for point-to-point NEIs,
	‘*’ for the auto-registration NEI (indexed by +WS176)
	status is: “Registered” or “No”

Page 104 2110212 Rev 1.0