Silex technology manual Access Internal Command Console, SX-550 Home

￿

To send configuration data to the serial device, press the Test button on the SX-550 module. The serial device should display or print the IP address assigned to the SX-550 module by your network DHCP service.

If your network does not use DHCP, then the SX-550 module will have the default IP address of 192.0.0.192.

Note: When using the SX-550 module wirelessly, verify you are communicating using AdHoc mode with the SSID configured as ‘serserv.’

3.Enter the password. The default password is ACCESS. The SX-550 configuration home page displays.

Figure 15 SX-550 Home Page

4.Continue to Chapter 6:

Setting Configuration Parameters.

Access Internal Command Console

You can access the Command Console by using the following methods:

•SX-550 Evaluation Daughtercard’s Ethernet port using a Telnet session

•SX-550 Evaluation Daughtercard’s serial port or console port using a terminal emulator

Page 28	silex	Accessing Configuration Parameters
	Part Number 40183-101