Command |
| Description |
|
| |
| This command is used for diagnostic purposes only. | |
| The default value is Disable. | |
| Sample output: |
|
| SET LOAd (ENable DIsable ] | |
SET LOAd HOst | Sets the node name of the Netware boot host. | |
| This command is used for diagnostic purposes only. | |
| The default value is null>\ |
|
| Sample output: |
|
| SET LOAd HOst | <name> |
SET LOAd IP | Sets source computer IP address for TFTP get operation. | |
| The default value is 0.0.0.0. | |
| Sample output: |
|
| SET LOAd IP | aa.bb.cc.dd |
SET LOAd | Sets filename on host for TFTP get update | |
SOftware | Sample output: |
|
|
| |
| SET LOAd SOftware <filename> | |
SET LOAd TFTP | Initiates firmware update using TFTP get operation. | |
| The TFTP server address must be set using SET LOAd IP and the filename using | |
| SET LOAd SOftware. The server will reset after the firmware update is completed. | |
| Sample output: |
|
| SET LOAd TFTP |
|
SET LOAd | Initiates firmware update using the XModem protocol on the serial console | |
XModem | The server will reset after the firmware update is completed. | |
| ||
| Sample output: |
|
| SET LOAd XModem | |
SH LOAd | Shows the firmware update parameters | |
| Sample output: |
|
| Firmware load is disabled | |
| Load Host IP | = 0.0.0.0 |
| Software file | = xxxx.bin |
| Load Host Name = | |
Page 72 | silex | Console Commands |
| Part Number |
|
