Silvercrest KH 2450 manual Using the voice recorder, Switching the voice recorder on

Úin battery/cell operation, the battery symbol ; the beams in the battery symbol indicate the current full resp. charged condition of the batteries.

Úin mains power/USB operation the symbol .

The voice recorder is now ready for use.

7. Using the voice recorder

7.1 Switching the voice recorder on

1To switch the voice recorder on: Press the button »ON/OFF« A once. The sta- tus lamp »DICT « D briefly lights up once. In the display Q the SilverCrest logo is briefly shown; indicated subsequently are:

Úshould the batteries/cells have been exchanged before switching on: the battery selection screen (see chapter 6 »Preparing the voice recorder for use«, step 3); the battery selection screen is not indicated if …

Úthe batteries/cells were not exchanged before switching on

Úthe switched-off voice recorder is connected to a PC via a USB cable (PC operation)

Úsubsequently the SilverCrest logo

Ú»INT«, should there not be a memory card inserted into the memory card slot O; in this case the internal memory of the voice recorder is used for dicta- tions.

Ú»EXT«, should there be an SD/MMC memory card inserted into the memory card slot O; in this case the memory card is used exclusively as an external memory for dictation recording.

During software loading phases the hourglass symbol in blended in briefly.

Consequently, a short signal tone sounds and the start screen appears with the following indicators/menu choices:

Should it be that no dictations have yet been saved:

14