12
The following jumpers are located on the module:
One 3-pin jumper (JP5) for which there are only two possibilities:
¾ Connecting pin 1 to pin 2 (which will be indicated as 1-2)
¾ Connecting pin 2 to pin 3 (which will be indicated as 2-3)
Three 2-pin jumpers (JP1, JP7, JP8), which can be set as follows:
¾ Pin 1 connected to pin 2 (which will be indicated as ‘Closed’)
¾ Pin 1 and pin 2 not connected (which will be indicated as ‘Open’)
The following table provides a quick cross-reference for the SpacePC 1232 module’s jumpers.
Table 1. Jumper Settings
PIN# Type Function Default
JP1 2 pin
jumper
Write protection on Bios Flash
Closed: Write not allowed on Boot Block
Open: Boot Block can be written Open
JP5 2 pin
jumper
Power Supply Source Selection for SSD Socket
1-2: Battery
2-3: VDD 2-3
JP7 2 pin
jumper
Invalid Setup
Open: Module starts with saved parameters
Closed: Module starts with default settings Open
JP8 2 pin
jumper
External BIOS
Open: Module starts with internal BIOS (inside Flash EPROM)
Closed: Module starts with External BIOS Open