-bit 0 of the MCR register = 0 means RS485 line receiving
-bit 0 of the MCR register = 1 means RS485 line transmitting
The I/O address of the MCR is "Serial port Base address"+4H.
See Chapter 4 for info about the Serial ports configuration.
J7 for 2 x USB, J8 for AUDIO-CODEC
J7 for 2 x USB
J7 is a double row 4 x 2 pin with
2 x USB
Figure 13. J7 Connector layout
Two USB ports are provided on the SpacePC 1232 module for the connection of USB devices.
Pin | Signal |
1 | PE |
2 | OC |
3 | USB1N |
4 | USB2N |
5 | USB1P |
6 | USB2P |
7 | GND |
8 | GND |
Table 11. J7 2 x USB connector
Function
USB power enable
USB over current sense
USB port 1 differential line (minus line)
USB port 2 differential line (minus line)
USB port 1 differential line (plus line)
USB port 2 differential line (plus line)
Ground signal
Ground signal
All the timers have the same input clocks with a nominal frequency of 1MHz.
All the gate inputs are pulled high by a 4.7K resistor
26
