Sony 5500 manual 158

Appendix

Item number	Item	Setting	Function
628	REMAIN TIME	[off]	Sets whether to display remaining time on the tape in
	DISPLAY	10min	superimposed character position.
		on	off: Do not display remaining time.
			10min: Display remaining time when it is 10 minutes or
			less.
			on: Always display remaining time.

			Note
			The	remaining time on the tape is not displayed when no
			cassette is inserted. The remaining time is not also
			displayed until the VTR finishes detecting the diameter of
			the wound tape and estimating the remaining time
			immediately after the cassette is inserted.
630	TC CONVERT	[off]	Selects whether to convert the playback time code to the
		on	operating frequency time code when tapes recorded with
			different frame rates are used for off-speed playback.
			off: Does not convert the time code.
			on: Converts the time code.
631	ORIGINAL TC	[off]	When item 630 is set to “on,” this setting specifies whether
	display	on	the 24-frame time code is displayed or not on the control
			panel of the VTR before conversion.
			off: The 24-frame time code is not displayed before
			conversion.
			on: The 24-frame time code is displayed before conversion.
			The type of time code displayed is specified by item
			603.
632	JUMPING TC	[ − 3H]	Sets the loopback point (JUMPING TC) for converting time
	select	–2H	code with respect to the reference time code (STARTING
			TC) for conversion.
		–1H
			–3H: The JUMPING TC is set 3 hours before STARTING
		+1H
			TC.
		+2H
			–2H: The JUMPING TC is set 2 hours before STARTING
		+3H
			TC.
		0H
			–1H: The JUMPING TC is set 1 hour before STARTING TC.
			+1H: The JUMPING TC is set 1 hour after STARTING TC.
			+2H: The JUMPING TC is set 2 hours after STARTING TC.
			+3H: The JUMPING TC is set 3 hours after STARTING TC.
			0H: The JUMPING TC is set 1 frame before STARTING TC.

Items Relating to the Video Control (Nos. 706 to ...)

Item number	Item	Setting	Function
706	FORCED	[auto]	Specifies whether or not Y-add operation mode is
	VERTICAL	forced YADD off	automatically turned on during DT playback.
	INTERPOLATION		auto: Y-add operation mode is automatically turned on.
	OFF		forced YADD off: Y-add operation mode is off all the time.
707	ROUNDING	[simple]	Selects whether to perform A-ROUNDINGTM 1) processing.
	(SRW-5500 only)	adaptive	simple: Do not perform A-ROUNDINGTMprocessing. 10-bit
			input signals are simply rounded to 8 bits.
			adaptive: Perform A-ROUNDINGTMprocessing. 10-bit
			input signals are adaptively rounded to 8 bits.

1)A-ROUNDING™

A method for rounding a 10 bit signal to 8 bits. This process suppresses step noise that occurs when lines which differ slightly from the horizontal are displayed.

A-ROUNDING is a trademark of Sony Corporation.

158 Menu List