Item number | Display | Meaning |
12 | TAPE TOP ERROR | A tape beginning sensor fault was detected. |
|
|
|
13 | TAPE END ERROR | A tape end sensor fault was detected. |
|
|
|
14 | FAN MOTOR ERROR | A cooling fan motor operation fault was detected. |
|
|
|
20 | CC TIME OVER | A fault was detected in a cassette compartment raising or lowering |
|
| operation. |
|
|
|
21 | SHIFT TIME OVER | A fault was detected movement of the reel table to adjust for |
|
| cassette size. |
|
|
|
22 | POSITION BOTH DETECT | The reel table was detected in the L cassette position and S |
|
| cassette position at the same time. |
|
|
|
23 | THREAD BOTH DETECT | The threading end and unthreading end were detected at the same |
|
| time. |
|
|
|
93 | DR IF ERROR | A communications error between the SV CPU (board |
|
| drum CPU (board |
|
|
|
97 | NVRAM CHECK SUM ERROR | An operation fault was detected in the servo system |
|
| (board |
|
|
|
FF | SV UNDEFINE ERROR | Undefined SV error was detected. |
|
|
|
A0 | SY UNDEFINE ERROR | Undefined SY error was detected. |
|
|
|
A2 | A DPRAM (board | |
|
| was detected. |
|
|
|
A5 | A DPRAM (board | |
|
| was detected. |
|
|
|
A8 | SY NVRAM CHECK SUM ERROR | A SYS NVRAM (board |
|
|
|
B8 | A SYS CPU communications fault was detected. | |
|
|
|
B9 | An SV CPU communications fault was detected. | |
|
|
|
BA | An EQ CPU communications fault was detected. | |
|
|
|
BB | An FC CPU communications fault was detected. | |
|
|
|
BC | A communications fault with the | |
|
|
|
Warning Messages
When one of the problems described below is detected, a warning mark is displayed in the upper left corner of the display. Operation can continue even when the mark is flashing.
If you press the SFT button (see page 19) and the DIAG button (see page 18) when the mark is flashing, an information display appears, showing a warning message.
Note
The warning messages can be viewed in any menu except the CUE or SET UP menu.
Only one message will be displayed even if there are multiple messages. The number of errors appears at the lower right, and you can check the messages using the R and r buttons.
A history of errors is kept in the error log menu.
For more information about warning messages, refer to the Maintenance Manual.
Use the displayed warning information to eliminate the cause of the warning.
For more information about eliminating the cause of warning, refer to the Maintenance Manual.
To automatically display a warning message Whenever a warning occurs, change the setting of the VTR SETUP menu item 120 “WARNING DISPLAY” to “on”.
Appendix
Error Messages and Warning Messages | 135 |
|
|