Note
When
•Below the input display in the audio level meter section, the DATA mark lights in white.
•For the audio level meters, all regions light.
•The analog audio outputs (main line/monitor/ headphones) are muted.
•The audio output level can be adjusted during
Overview
When using
During program play you can correct the pitch of audio signals.
Note
The program play function is available only when all of the following conditions are met.
•Combination of
•Tape format:
•System frequency: 4:2:2/1080/59.94i or 720/59.94P. No audio is output when playing tapes recorded at other system frequencies.
•Note about editing: Always use time code to check and set edit points when editing while performing program play on the player. Precise editing operations cannot be guaranteed if you use CTL signals.
To execute program play
Proceed as follows to execute program play.
3 4
5
1 Set the same system setting for the VTR main unit and for FC output.
HD SDI signals will be output from both the HD SDI OUTPUT connectors and the FC OUT connectors.
2 Set VTR SETUP menu item 020 “P PLAY” to “on”. 3 Press the HOME button.
The HOME menu appears.
4 Turn the MULTI CONTROL knob to set the program play speed.
5 Press the PLAY button and VAR button at the same time.
Program play starts at the specified speed.
Note
During program play, HD SDI signals are output from the FC OUT connectors only. They are not output from the HD SDI OUTPUT connectors.
About audio pitch correction
Some menu settings are required to enable audio pitch correction during program play.
When audio pitch correction is enabled, it is also carried out at times other than during program play, whenever an
23.98frames y 24 frames 23.98/24 frames y 25 frames
29.97frames y 30 frames
To enable pitch correction
Set VTR SETUP menu item 816 “PITCH
CORRECTION” to “on”.
Pitch correction group settings
You can use VTR SETUP menu item 817 “PITCH CORRECTION GROUP select” to assign the 12 audio channels to groups.
You can assign up to 6 channels to 1 group. Pitch correction is performed at the same time for all channels in a group, so phase differences do not arise. However, phase differences may arise between different groups.
Pitch correction detection mode settings You can use VTR SETUP menu item 818 “PITCH CORRECTION DETECT MODE select” to specify the detection mode for each pitch correction group.
Mode1: Search for
Recording/Playback 5 Chapter