Sony AR-208S operation manual Bypass Feed including special paper, Envelopes

BYPASS FEED (including special paper)

The bypass tray can be used to feed standard paper, transparency film, labels, envelopes, and other special purpose paper.

Important points when inserting paper in the bypass tray

Up to 50 sheets of standard copy paper can be inserted in the bypass tray. (Capacity will vary depending on the type of paper loaded.)

Be sure to place envelopes horizontally as shown in the following diagram.

2

Available Not

Available

•When loading envelopes, make sure that they are straight and flat and do not have loosely glued construction flaps (not the closure flap).

•Special papers such as SHARP recommended transparency film, labels, and envelopes must be fed one sheet at a time through the bypass tray.

•When adding paper, first remove any paper remaining in the tray, combine it with the paper to be added and then reload as a single stack. The paper to be added must be the same size and type as the paper already in the tray.

•Do not use paper that is smaller than the original. This may cause smudges or unclean images.

•Do not use paper that has already been printed on by a laser printer or plain paper fax machine. This may cause smudges or unclean images.

Envelopes

Do not use the following envelopes, as misfeeds will occur.

•Envelopes with metal tabs, clasps, strings, holes, or windows.

•Envelopes with rough fibers, carbon paper, or glossy surfaces.

•Envelopes with two or more flaps.

•Envelopes with tape, film, or paper attached to the flap.

•Envelopes with a fold in the flap.

•Envelopes with glue on the flap to be moistened for sealing.

•Envelopes with labels or stamps.

•Envelopes that are slightly inflated with air.

•Envelopes with glue protruding from the seal area.

•Envelopes with part of the seal area peeled off.

•Be sure to select com9, com10 or Monarch in the paper size setting of the printer driver. (For detailed information on the printer driver, refer to the online manual.)

17