Setting the Input Configuration — INPUT CONFIGURATION Menu
2 Chapter Menus
[C111] COMPOSITE menu
Select the format of a composite or Y/C signal. AUTO: The format of the input signal is detected and
switched automatically.
It will take a few seconds to detect the format of an input signal when AUTO is selected. It is recommended that a particular format be selected if it is determined.
NTSC: SETUP 7.5 or 0.
PAL: S (simple) or D (delay).
SECAM
Notes
•Even when selecting AUTO, also select the NTSC, PAL, or
•If there is no input connector or decoder corresponding to a format, that format will not be selectable (the cursor will skip over that entry).
•When the
•When inputting the
[C112] COMPONENT menu
Select the component signal format, or RGB.
YUV
YUV BETACAM: SETUP 7.5 or 0
RGB
[C113] SDI menu
Select the format of the serial digital signal.
AUTO: The format of the input signal is detected and switched automatically.
•It will take a few seconds to detect the format of an input signal when AUTO is selected. It is recommended that a particular format be selected if it is determined.
•If the serial digital signal is not properly displayed at SDI AUTO mode,
[C12] YC SEP menu
Select a Y/C separation filter. TRAP/BPF: Select TRAP/BPF filter.
2 LINES COMB: Select 2 LINES COMB filter.
3 LINES COMB: Select 3 LINES COMB filter.
[C13] SCREEN MODE menu Select the scan size.
[C14] SCALE menu
Select the setting for each items of SAFE AREA setting list.
80:Displays a 80% safe area in 4:3 screen.
90:Displays a 90% safe area in 4:3 screen.
100:Displays an 100% safe area in 4:3 screen.
area in 4:3 screen.
[C15] CHANNEL NAME menu
Give the channel a name. Select a preset name, or enter a new one.
PROG: Program signal.
EDIT: Signal from an editor.
CAM: Camera signal.
VTR: Signal from a VTR.
NEW NAME: Enter a new name. (Up to 20 characters can be entered and up to six characters from the head of the name are displayed in the INPUT CONFIGURATION menu ([C1], 2/2).)
NTSC: SETUP 7.5 or 0
PAL: S (simpe) or D (delay)
4:2:2
36