1 Chapter Overview

Location and Function of Parts

This manual explains the location and function of parts and controls using the control panel of the BVM- 14F5U/14F5E/14E5U/14E5E. The explanation applies to BVM-20F1U/20F1E/20E1U/20E1E/14F1U/14F1E/ 14E1U/14E1E with the BKM-10R/11R Monitor Control Unit.

1Tally lamp

With factory settings, the Tally lamp lights when pins No. 8 and No. 9 of the REMOTE 2 connector on the rear panel are shorted. By changing the setting in the REMOTE menu, different pins on the remote connector can be used to control the tally lamp.

For details of the REMOTE menu, see “Assigning the Remote Control Functions —REMOTE Menu” on page 38.

2POWER switch

Press to turn on/off the monitor. By setting with the ADDRESS menu, it is possible to turn on/off the power of the specified monitors only, or of all monitors at the same time.

For details of the ADDRESS menu, see “Selecting the Monitor to Control - ADDRESS Menu” on page 54.

3DEGAUSS button

Press to degauss the CRT (every time the monitor is turned on, the CRT is degaussed automatically). To degauss again, wait for more than five minutes.

4Numeric keypad

Use to designate the channel number for the input signal to be monitored, or to enter the setting values with the menus.

 

INPUT

 

 

1

2

3

 

4

5

6

Numeric buttons

7

8

9

 

Del

0

Ent

Ent button: Confirms the

 

 

 

values and characters entered

(ENTER button of the menu operation buttons 6 has the same function).

Del button: Deletes the values and characters entered.

Channel number entry method:

(In the explanation below, x represents any digit between 1 and 9, and y represents any digit between 0 and 9.)

When selecting a channel number from 1 to 9, press the x button to display channel x. When selecting a channel number from 10 to 99, press the 0, x, and y buttons to display channel xy (a two-digit channel number).

5MANUAL adjustment buttons and knobs Each press of one of these buttons turns the button’s green LED on or off. When the corresponding button is on (lit), it is possible to manually adjust the contrast, brightness, chroma and phase by turning the corresponding knobs. They are also used to enter the setting values with the menus. It is possible to set the preset value for each adjusting item with the CONTROL PRESET ADJ menu.

For details of the CONTROL PRESET ADJ menu, see “Preset Adjustment of the Picture Level Control Knobs - CONTROL PRESET ADJ menu” on page 25.

Notes

When using the composite SECAM, composite PAL D, component or SDI (component or composite serial digital interface) format, note the following.

•The signal phase cannot be adjusted.

•The phase and chroma of RGB signals cannot be adjusted.

CONTRAST MANUAL

CONTRAST button and knob

BRIGHT

BRIGHT button and knob

CHROMA

CHROMA button and knob

PHASE

PHASE button and knob: Changes the items and settings on the menus

10