Constituent Menus of the SET UP / EXTEND Menu

This section describes the functions of the constituent menus of the SET UP/EXTEND menu.

Notes

•The menu numbers (A, B1, C11 and so on) are not displayed on the monitor screen.

For details menu numbers, see page 20.

•An arrow (÷) following the description of an item or setting in each menu indicates another menu which appears or an operation which is executed when you select that menu item or setting. If the description of an item or setting is not followed by an arrow, it indicates that selecting the item or setting finishes the setting operation.

[C7] EXTEND menu

Enter the password (ENTER PASSWORD [C71]). When the correct password is entered, the following item appears. Choose the function to execute.

RE-LOAD FACTORY DATA...: Restore factory default data for the board installed in the selected slot. ÷[C711]

MEMORY CARD...: Read and write setting and adjustment data by using the monitor memory card. ÷[C712]

RE-START MONITOR: Restart the monitor. ÷ [C713]

ADJ INT SIGNAL: Automatically adjust the SETUP level and 100 IRE level of internal signals. ÷[C714]

[C711] RE-LOAD FACTORY DATA menu

Select a slot where a board is installed to reload factory default data to the board. ÷[C7111]

Note

You can only select slots 6 and 7. However, when the optional board has been installed, you can also select slot 2.

[C7111] SLOT1 to SLOT9

The following message appears, requiring your confirmation about data reloading.

DATA RESET TO

ITS FACTORY SETTING

AND MONITOR WILL RESTART

ARE YOU SURE?

OK : ENTER KEY

CANCEL : MENU KEY

OK: To continue, press the ENTER button. ÷ Resets the data and automatically turn the monitor off and on again.

CANCEL: To cancel, press the MENU button. ÷ Returns to the RE-LOAD FACTORY DATA menu. ([C711])

[C712] MEMORY CARD menu

Insert the monitor memory card into the MEMORY CARD slot and select the operation to perform.

BACK UP SYSTEM DATA...: Write the data to the monitor memory card. ÷[C7121]

RE-STORE SYSTEM DATA...: Read the data from the monitor memory card. ÷[C7122]

Notes

•Before a monitor memory card can be used, it must be formatted it with the FORMAT menu ([D4]).

•System data and memory card data ([D]) cannot be stored on the same memory card. To store memory card data, use another memory card.

•The BKM-12Y monitor memory card has a capacity of 256 Kbytes. It can store either system data for up to 8 monitors or 38 files of memory card data.

[C7121] BACK UP SYSTEM DATA menu

While the system is writing the data, a “–” mark blinks at the top right of the menu. (It takes some time to save the data.)

BACK UP SYSTEM DATA

IN PROGRESS...SYSTEM

2 Chapter Menus

49