Constituent Menus of the SET UP / SYSTEM CONFIGURATION Menu

This section describes the functions of the constituent menus of the SET UP/SYSTEM CONFIGURATION menu.

Notes

•The menu numbers (A, B1, C11 and so on) are not displayed on the monitor screen.

For details of menu numbers, see page 20.

•An arrow (÷) following the description of an item or setting in each menu indicates another menu which appears or an operation which is executed when you select that menu item or setting. If the description of an item or setting is not followed by an arrow, it indicates that selecting the item or setting finishes the setting operation.

[C4] SYSTEM CONFIGURATION menu Set each of the various items.

INPUT SELECT: Select the channel number entry method (DIRECT or 10KEY).

(In the explanation below, x and y represent any digit between 1 and 9.)

DIRECT mode: To select channel x, press the x button. To select channel xy (a two-digit channel number), press the 0, x, and y buttons in this order.

10KEY mode: To select channel x, press the x button, then the ENTER button. To select channel xy (a two-digit channel number), press the x, y, and ENTER button in this order.

When multiple monitors are connected by a serial remote connection, this setting will be common to all the monitors. It is not possible to change the setting for individual monitors.

STANDBY MODE: Select the power-up condition

when the MAIN POWER switch is turned on (OFF or ON).

ON: Standby mode

OFF: Operation mode

DEFAULT CH: Select the power-up input channel (LAST or CH xx).

LAST: Set the channel to the channel that was selected at the time the power was last turned off.

CH xx: Set the channel to a specific channel number.

DEGAUSS DELAY: Set the time between power-up and the beginning of degaussing. Enter the desired time (in seconds).

AFC TIME: Select the AFC time constant (SLOW or FAST).

RESIDUAL SC SW: Switch the residual switch (OFF or ON).

ACC SW: Switch the ACC switch (OFF or ON).

CONT/BRT HOLD: Select the contrast and brightness settings to the center or adjusted value after adjusting the white balance or auto adjustment of CONTROL PRESET (OFF or ON). ON: The contrast and brightness are set to the

value before adjusting.

OFF: The contrast and brightness are set to the center value (1000) after adjusting.

COL TEMP SHORT-CUT: Assign the shortcut function to the MANUAL menu of the COLOR TEMP ADJ menu to [F2] key (OFF or ON). ON: Assigns the shortcut to the MANUAL menu

of the COLOR TEMP ADJ menu. OFF: Do not assign the shortcut to the

MANUAL menu of the COLOR TEMP ADJ menu.

2 Chapter Menus

43