Constituent Menus of the SET UP / REMOTE Menu

This section describes the functions of the constituent menus of the SET UP/REMOTE menu.

Notes

•The menu numbers (A, B1, C11 and so on) are not displayed on the monitor screen.

For details of menu numbers, see page 20.

•An arrow (÷) following the description of an item or setting in each menu indicates another menu which appears or an operation which is executed when you select that menu item or setting. If the description of an item or setting is not followed by an arrow, it indicates that selecting the item or setting finishes the setting operation.

[C2] REMOTE menu

Select the type of remote control.

REMOTE 1 CONFIG...: Set the address and group number of the monitor controlled via the REMOTE 1 (serial remote control) connector. ÷ [C21]

REMOTE 2 CONFIG...: Set the pin assignments for the REMOTE2 (parallel remote control) connector. ÷[C22]

REMOTE 2: Select whether or not parallel remote control will be used (ON or OFF).

[C21] REMOTE 1 CONFIG menu

Set the monitor address, group address and remote mode of the monitor.

MONITOR ADDRESS: Enter a number.

GROUP ADDRESS: Enter a number.

REMOTE MODE: Select the remote mode. ÷ [C211]

[C211] REMOTE MODE menu

Select a remote mode according to the type of monitors connected through the REMOTE 1 connector.

When only Sony BVM-xxE/F/G or HDM-xxE series monitors are connected: set REMOTE MODE to 0.

When a Sony BVM-xx11/16 series monitor or a Sony PVM monitor (with BKM-103 Serial Remote Interface Kit installed) is connected: set REMOTE MODE to 1 and enter a number over 64 as the MONITOR ADDRESS for each connected Sony BVM-xxE/F/G and HDM-xxE series monitor.

[C22] REMOTE 2 CONFIG menu

Select the REMOTE 2 connector pins for which you want to change the function. The factory settings for each pin are given below. ÷[C211]

1 PIN...: CH01

2 PIN...: CH02

3 PIN...: EXT SYNC

4 PIN...: MONO

5 PIN...: SAFE AREA

6 PIN...: unused

7 PIN...: unused

8 PIN...: TALLY

[C221](1/2) 1-8 PIN menu (1/2) Assign a function to the selected pin.

CH: Select a channel number. Enter the desired channel number with the numeric keypad.

----:Set to unused.

UNDERSCAN: Set underscan on or off.

16:9: Set a 16:9 aspect ratio on or off.

H DELAY: Set the horizontal sync display on or off.

V DELAY: Set the vertical sync display on or off.

EXT SYNC: Set the synchronization to external sync signals enabled or disabled.

COMB: Set the comb filter on or off.

APERTURE: Set the correction of frequency characteristics enabled or disabled.

MONO: Set monochrome display on or off.

[C221](2/2) 1-8 PIN menu (2/2) Assign a function to the selected pin.

BLUE ONLY: Set the blue signal pictures display (monochrome) on or off.

R OFF: Set cutting red beams enabled or disabled.

G OFF: Set cutting green beams enabled or disabled.

B OFF: Set cutting blue beams enabled or disabled.

VITC ON: Set the VITC display on or off.

SAFE AREA ON: Set the safe area display on or off.

CAPTION VISION: Set the caption vision on or off.

TALLY ON: Set tally signals on or off.

DEGAUSS ON: Set degaussing on or off.

POWER OFF: Set the monitor power on or off.

For details of pin connections, see the description of the REMOTE 2 connector on page 17.

2 Chapter Menus

39