Constituent Menus of the SET UP / INPUT CONFIGURATION Menu

This section describes the functions of the constituent menus of the SET UP/INPUT CONFIGURATION menu.

Notes

•The menu numbers (A, B1, C11 and so on) are not displayed on the monitor screen.

For details of menu numbers, see page 20.

•An arrow (÷) following the description of an item or setting in each menu indicates another menu which appears or an operation which is executed when you select that menu item or setting. If the description of an item or setting is not followed by an arrow, it indicates that selecting the item or setting finishes the setting operation.

[C1](1/2) INPUT CONFIGURATION menu (1/2) Set input signal data for each channel.

xxCH: Current channel is indicated. Enter a channel number with the numeric keypad if changing the channel. The settings below will be stored as information about the signal to be connected to this channel.

FORMAT...: Select the input signal type. ÷[C11]

SLOT NO: Enter the slot number.

INPUT NO: Enter the input connector number.

YC SEP...: Select a Y/C separation filter. ÷[C12]

SYNC MODE: Select the sync signal. INT: Use an internal sync signal. EXT: Use an external sync signal.

SCREEN MODE...: Select the scan size. ÷[C13]

SAFE AREA: Choose whether or not to display the safe area (OFF or ON).

SCALE...: Select the safe area size. ÷[C14]

APERTURE: Choose whether or not to use aperture adjustment (OFF or ON).

VALUE: Enter the aperture adjustment value (0 to 200).

[C1](2/2) INPUT CONFIGURATION menu (2/2) Set input signal data for each channel.

xxCH: Current channel is indicated. Enter a channel number with the numeric keypad if changing the channel. The settings below will be stored as information about the signal to be connected to this channel.

FILTER: Switch the filter operation (OFF or ON) when the monochrome display is selected.

CHANNEL NAME...: Give the channel a name. ÷ [C15]

CONTROL: Select whether to use local (“CH SET”) or common (“PRESET”) values for contrast, brightness, chroma, and phase.

PRESET: Use common data.

CH SET: Use values set for each channel. COLOR TEMP...: Set the color temperature. ÷

[C16]

H PHASE: Set the horizontal picture position (–128 to +127).1)

SAD H POSITION: Adjust the horizontal display position of the safety area (–128 to +127). 1)

COPY...: Select a method for copying data from elsewhere. ÷[C17]

1)The monitor will not operate correctly if values above or below the allowable range are entered.

[C11] FORMAT menu

Select the signal format.

COMPOSITE...: Composite signal. ÷[C111]

YC...: Y/C signal. ÷[C111]

COMPONENT...: Component or RGB signal. ÷ [C112]

SDI...: Serial digital signal. ÷[C113]

Note

If there is no input connector or decoder corresponding to a format, that format will not be selectable (the cursor will skip over that item).

2 Chapter Menus

35