Location and Function of Parts

1 Chapter Overview

0SHIFT button

Press to select one of the two functions designated to the function buttons !¡.

Each time the SHIFT button is pressed, the LED turns on (SHIFT ON: lit in orange) and off (SHIFT OFF: lit in green).

SHIFT OFF: The functions indicated on the left side of the function buttons can be used.

SHIFT ON: The functions indicated on the right side of the function buttons can be used.

!¡ Function buttons

Change the operation conditions for the monitor. Each time the button is pressed, the LED turns on and turns off, and the operation conditions are changed. Each button has two functions. Select one of the two functions by pressing the SHIFT button 0. When the SHIFT button is set to ON, the LED lights in orange, and when the SHIFT button is set to OFF, the LED of each button lights in green.

SHIFT OFF (LEDs of function buttons in green)

16 : 9

SYNC

BLUE

ONLY

MONO R

APT G

COMB B

(Underscan) button: When this button is pushed in (ON), the picture is underscanned by 3%, and four ends of the raster is displayed on the screen.

(H delay) button: When this button is pushed in (ON), the picture moves horizontally, and a horizontal sync signal appears approximately one quarter in the left edge of the screen.

•The brightness of the picture increases automatically, and it makes it easy to check the sync part.

•If it is pressed together with the button, a pulse cross picture is displayed.

(V delay) button: When this button is pushed in (ON), the picture moves vertically, and a vertical sync signal appears approximately in the center of the screen.

•The brightness of the picture increases automatically, and it makes it easy to check the sync part.

•If it is pressed together with button, a pulse cross picture is displayed.

MONO button: When this button is pushed in (ON), a monochrome picture is displayed. When the buttons is off, the monitor switches automatically between color and monochrome mode, depending on the presence or absence of color burst signal.

APT (aperture) button: When this button is pushed in (ON), the frequency response can be modified. The degree of modification is set with the menu.

This function is available when an optional decoder adaptor such as a BKM-24N is installed.

COMB button: Turn the comb filter on and off.

This function is available when an optional decoder adaptor such as a BKM-24N is installed.

F1 F3

F2 F4

SAFE

ADDRESS AREA

F1 button: When this button is pushed in (ON), the characters disappear from the monitor on the MANUAL menu of the level 2 of the CONTROL PRESET ADJ menu, the MANUAL menu of the level 2 of the COLOR TEMP ADJ menu, and the ALIGNMENT menu of the level 2 of SETUP menu.

F2 button: When this button is pushed in (ON), you can access directly the MANUAL menu of the level 2 of the COLOR TEMP ADJ menu, if the short-cut function is assigned to this button.

For details of short-cut functions, see “Setting the Channel Selection Method and Power-Up Conditions – System Configuration Menu” on page 42.

ADDRESS button: When this button is pushed in (ON), the ADDRESS menu appears

on the screen. By using the ADDRESS menu, operation conditions for multiple monitors are set.

For details of the ADDRESS menu, see “Selecting the Monitor to Control - ADDRESS

Menu” on page 54.

12