2

)

7

£ 8

$ › 1 ¡

•

 

 

5 4 1 3

1

1 ¡

2AUTO START ID

3

REC

4

RM-D690A

4

¢

1

2

3

 

4

5

6

 

 

 

7

8

9

 

 

 

 

0

 

 

 

PGM NO.

a)

5

3

8

 

 

PAUSE

 

 

Program

Numbers

Writing program numbers from the middle of the tape

1 To locate the last point of the previous recording, using the end search function. (Ppage 26)

It is important to proceed with the end search function in order not to leave a blank section on the tape.

2 Make sure that the AUTO indicator is lit. If it is not lit, press the START ID AUTO button.

When turning on the power and inserting a cassette with its safety tab at the record-possible position, the AUTO indicator lights.

In timer recording, the AUTO indicator will be the same as the one before the power is turned off.

3 Press the REC button to set the deck in the record-pause mode.

4 Designate the next program number (the number that follows the program number of the last selection) with the numeric button on the remote commander.

If you are not aware of the program number, press the 4button to check the last program number (After checking the program number, locate the last point of the previous recording, using the end search function.)

If the program number of the last selection appears at the PGM NO. displayyou need not to designate the next number.a) Next program numberIf the next program number is not designatedThe start IDs will be written, but the program numbers will not.

You can write the program numbers using the renumbering function described on the next page.

5 Press the 8PAUSE or 3(play) button.

The program numbers are written consecutively, beginning from the designated number at the same position as the start ID.

35