Symptom |
| Cause |
| Remedy |
Sub codes cannot be written.
Insert a cassette tape with its safety tab at the
Insert a cassette tape with its safety tab at the
Start ID cannot be written during recording.
A new start ID cannot be written within 9 seconds (18 seconds in the
Leave at least 9 seconds (18 seconds in the
Search function does not operate during playback.
The start ID is not written correctly. | Erase it (page 33), and then write it again. |
The portion between the end of a start ID and the beginning of the following start ID is less than 9 seconds (18 seconds in the
The selected program number does not exist on the tape.
The program numbers are out of order.
When writing the start IDs manually, write so that the intervals between them are more than 9 seconds (18 seconds in the
Use the RENUMBER button to
Search function operates suddenly during playback.
The skip play function is operating. (The SKIP indicator lights in the display window.)
The repeat play function is operating.
Turn off the indicator by pressing SKIP PLAY.
Turn off the indicator by pressing REPEAT 1/ALL.
Search function stops. | There is a blank section between |
| selections. (The sampling frequency |
| indicator blinks on the display.) |
Use the end search function (page 26) when recording so that no blank is created.
The tape operation buttons do not operate | While writing the start ID (9 seconds or 18 | Operate after the start ID is written. | |
while writing the start ID. | seconds), none of the buttons except the 7 |
| |
|
| button are operative. |
|
|
|
|
|
The absolute time codes cannot be written. | Recording was started from the blank | Rewind the tape to the beginning, or locate | |
|
| section. | the very last point of the previous recording |
|
|
| by using the end search function (page |
|
|
| 26), and start recording from the point. |
|
|
|
|
End ID cannot be written during playback. | The portion where you want to write the | Set the deck in the | |
|
| end ID is blank. | pressing ¶REC, then write the end ID. |
|
|
|
|
Renumbering function does not operate. | The portion between the end of a start ID | When writing the start IDs manually, write | |
|
| and the beginning of the following start ID | so that the intervals between them are |
|
| ||
Start ID cannot be erased. | is less than 9 seconds (18 seconds in the | more than 9 seconds (18 seconds in the | |
|
| ||
|
|
| |
Skip ID cannot be erased. | Two skip IDs are written continuously. | When writing the skip IDs, write so that the | |
|
|
| intervals between them are more than 1 |
|
|
| second (2 seconds in the |
End ID cannot be erased.
The end ID is written at the beginning of the tape.
The end ID is written immediately after a start ID.
Start recording from the beginning of the tape.
First erase the start ID.
57