Rear Panel

2S-VIDEO IN connectors

3 VIDEO IN connectors

4 VIDEO OUT connector

Overview

1 MAIN POWER switch

qd -AC IN connector

5 S-VIDEO OUT connector

6 MONITOR AUDIO connector

7 AUDIO OUT L/R connectors

8 AUDIO IN L/R connectors

9 REMOTE IN RS-232C connector

0 DV IN (i.LINK) connector

qa USB connector

qs Equipotential ground terminal connector

1MAIN POWER switch

Switch to the = side to turn the power on. Switch to the z side to turn the power off. Normally you should leave this switch in the on position and power the unit on and off with the power switch on the front panel.

Note

If you need to turn the main power off when not using the unit for long periods and so on, always power the unit off with the 1 (power) switch on the front panel before setting this switch to off.

2S-VIDEO IN connectors (4-pin mini DIN) The left S-VIDEO IN connector inputs analog S video signals.

The two connectors are loop-through connectors. If you connect S video input signals to the left connector, you can bridge-connect the signal to

other equipment via the right connector (marked ). Thus the same signals which are input to the left connector are output from the right connector to other equipment. When no connection is made to

the right connector, the left connector is terminated automatically with an impedance of 75 Ω.

3VIDEO IN connectors (BNC type)

The left VIDEO IN connector inputs analog composite video signals.

The two connectors are loop-through connectors. If you connect composite video signals to the left connector, you can bridge-connect the signal to other equipment via the right connector (marked

). Thus the same signals which are input to the left connector are output from the right connector to other equipment. When no connection is made to the right connector, the left connector is terminated automatically with an impedance of 75 Ω.

4VIDEO OUT connector (BNC type)

This connector outputs analog composite video signals.

5S-VIDEO OUT connector (4-pin mini DIN) This connector outputs the analog S video signals.

6MONITOR AUDIO connector (phono jack) This connector outputs monaural audio signals for monitoring.

The audio signals to be output from this connector can be selected among from audio channel 1, audio channel 2, or mixed audio signals, using AUDIO MON CH (see page 47) of the SETUP MENU.

7AUDIO OUT L/R connectors (phono jack) These connectors output analog audio signals.

8AUDIO IN L/R connectors (phono jack) These connectors input analog audio signals.

9REMOTE IN RS-232C connector (9-pin)This is a 9-pin RS-232C interface which is compatible with the SVO-9500MD video cassette recorder protocol.

Location and Function of Parts

11